ep

January 4, 2021

1.A connecting link of an O-ring Chain for general application is pre-coated with grease on the pins. Ahead of connection, confirm the grease about the surfaces of pins, and should the level of grease is small, apply grease with bare hands. (If gloves are employed, the grease is going to be absorbed from the gloves.)
Example: When the connecting hyperlink (I) of an O-ring chain for common application is
shipped, O-rings are fitted with the roots on the pins. If your O-rings come loose as a consequence of vibration all through transport, refit the O-rings in to the roots in the pins.
In this case, you should definitely return the grease collected with the roots of the pins for the central surfaces of the pins, additional at portion A than at portions B shown while in the over illustration. (Portions A is worn because of sliding using the bushings.)
2.The chain is often most simply linked about the teeth of the sprocket. Engage the hyperlinks at both ends in the chain together with the sprocket teeth and fit connecting pins. When the sprocket might be moved, the chain may also be linked within the loosened side.
three. Connecting process
1.Verify that O-rings are connected for the roots of your pins.
two.In case the volume of grease applied to the connecting pins is smaller, coat the pins with grease in the central portions.
3.Insert the connecting pins to the bushings of the inner hyperlinks at each ends.
4.Verify that the grease is applied to your complete encounter on the O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins into the connecting plate and when pressing the connecting plate, install the spring clip. Confirm whether or not the head (the end without a split) with the spring clip is turned within the feeding direction in the chain. (See the next illustration.)
6.Be sure to confirm the spring clip is securely fitted in the clip grooves in the connecting pins.
This completes jointing in the connecting link. Note that grease to the surfaces of connecting pins and O-rings is usually eliminated all through set up get the job done. In this instance, re-grease working with the grease around the surface on the base chain or even the grease during the polyethylene bag through which the connecting website link was contained.