ep

January 20, 2021

Energy UNITS FOR LIFT TABLE one
Standard Description
This power unit is built exclusively to the tiny lift table,Consisting of high strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit has become broadly utilized inside the marketplace of logistic devices for instance minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is controlled from the solenoid valve together with the pace managed through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Standard Description
This power unit is built exclusively for the medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve and also the pace managed by the adjustable needle valve. Once the lift rises to a higher positoin, but the electrical power provide is reduce, the reducing movement is controlled from the guide override perform.
Power UNITS FOR LIFT TABLE 3
Common Description
This power unit is created solely for that large lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve and also the speed controlled by a stress compensated movement management valve.
Energy UNITS FOR LIFT TABLE 4
General Description
This energy unit is designed exclusively for your huge lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve as well as the pace managed by the adjustable needle valve. Once the lift rises to a higher positoin, but the electrical power supply is lower, the lowering movement is controlled from the manual override perform.
Particular Notes
one. This electrical power unit is of S3 duty cycle, which might only get the job done intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic elements concerned ahead of installation of the power unit.
three. Viscosity with the oil shoud be 15~46 cst,which must also be clean and cost-free of impurities.N46 hydraulic oil is proposed.
4. Oil transforming is required right after the preliminary 100 operation hours,afterwards once each 3000 hours.
five. The power unit shown is created to be mounted vertically.